with Solved Example Problems
Subject and UNIT: Basic Electrical and Electronics Engineering: Unit I: Electrical Circuits
A set of resistances are connected in series if the same current flows through them and there is only one path for the current flow throughout.
Definition, Formula
Subject and UNIT: Basic Electrical and Electronics Engineering: Unit I: Electrical Circuits
The ratio of potential difference between any two points of a conductor to the current flowing through it, is constant provided the physical conditions (i.e., temperature, etc.) do not change.
Subject and UNIT: Basic Electrical and Electronics Engineering: Unit I: Electrical Circuits
The source which supplies the active power to the network is known as the electrical source.
Electrical Circuits
Subject and UNIT: Basic Electrical and Electronics Engineering: Unit I: Electrical Circuits
An electrical network is an interconnection of electrical elements linked together in a closed path so that an electric current may flow continuously.
Subject and UNIT: Basic Electrical and Electronics Engineering: Unit I: Electrical Circuits
Circuit element can be classified in many aspects.
Subject and UNIT: Basic Electrical and Electronics Engineering: Unit I: Electrical Circuits
Electric current is the rate of flow of electric charges. Electrons are negatively charged particles and their flow in conductors results in electric current.
Introduction
Subject and UNIT: Basic Electrical and Electronics Engineering: Unit I: Electrical Circuits
A circuit consists of electrical elements connected together. Electrical circuits used in generation, transmission and consumption of electric power and energy.
Engineering Graphics (EG)
Subject and UNIT: Engineering Graphics: Model Question Paper
Answer any one question from each unit. First angle projection to be followed.
Engineering Graphics (EG)
Subject and UNIT: Engineering Graphics: Model Question Paper
Answer any one question from each unit. First angle projection to be followed.
Engineering Graphics (EG)
Subject and UNIT: Engineering Graphics: Unit V (b): Perspective Projection
1. Draw the perspective view of a square plane with 35 mm side resting on ground plane with one of its corners touching PP and a side right to the corner is inclined at 30° to it.
Engineering Graphics (EG)
Subject and UNIT: Engineering Graphics: Unit V (b): Perspective Projection
So far the perspective view of objects are drawn by visual ray method.
Engineering Graphics (EG)
Subject and UNIT: Engineering Graphics: Unit V (b): Perspective Projection
The perspective projection of an object may be drawn by visual ray method by projecting any one set of its orthographic projections.